Shawl "Clematis": scheme and description of work
Shawl "Clematis", scheme and description of productionwhich will be presented in our article, is a knitted product of incredible beauty of a semicircular shape. At the heart of her creation is the napkin of Herbert Nybling. She was very beautiful and was made in the form of a circle or a semicircle. On average, the size of this shawl is 120 cm in width and 55 in height, but they can be varied for themselves. Knitting this shawl is a rather complicated and laborious work, but the result is worth it.
Preparation for work
So, we already know that the shawl "Clematis", the scheme andthe description of which will be considered in this article, has the form of a semicircle. If the standard dimensions (1.2 m by 0.55 m) do not suit, then you can change them. But this is under the power of experienced knitters.
In order to connect this thing, yarn is usefullinen, cotton, bamboo or wool. It is very important that the threads have natural fibers (approximate footage - 500 meters per 100 grams). Consumption of yarn during work will be about one hundred grams.
Even in the work will be useful knitting needles, a hook and twenty markers.
Shawl "Clematis" usually knit, starting from the center of the upper cervical margin and moving to the lower border.
The upper edge of the shawl is a ribbon made ofseveral loops - 2, 3 or 4 (this is how someone likes - to choose from). They must be tied in both the facial and the purl rows, with the loops exclusively facial. To create a ribbon, the first edge should be removed without tying, then insert the needle from the right to the left (as in the case of the back knitting), the thread must be on top of the work; Other hinges knit with facial, and, as in the front, and in the purl rows. The last edge band of the tape should be tied with the front behind the back wall.
That's the way to start the work so that in the endIt turned out a beautiful shawl "Clematis". The scheme of it (or rather, all the circuits) should be read from the right side to the left and from the bottom up. In these schemes only the front rows are indicated. And in purl all the hinges need to be knitted with purl, unless there are some agreed among them (it should be looked at in the conventional notation). Unfilled cells do not mean anything.
How to "cut" rapport
Due to the fact that the original design schemewas made for knitting a round napkin in order to work on a shawl, on the diagrams yellow lines denote the "slit" of the rapport. To be able to tie the canvas with turns in different directions - front and back.
This is how the shawl "Clematis" fits together. The diagram and description presented in this article give an idea about everything.
The buttonhole, which is marked on both sides with a yellow marker, will be the first in a row after the ribbon on the right and the last one - in front of the ribbon of the left.
In the end, it seems that one rapportthe left part of it will be tied at the beginning of the row (everything starts with a loop that is marked with yellow lines), and the right one will be at the end of the row and will end in exactly the same way - with a loop marked with a yellow marker.
Among such half rapport should be linkedseveral full rapports - 4, 5, 6 or 7. Therefore, the shawl "Clematis" after finishing work on it will look like a cloak-cape. This working scheme is designed for five rapports.
The first scheme
The first stage of the work includes knitting, in whichScheme No. 1 is used. At the very beginning, you should type three or four loops on the spokes. Then you need to tie twenty rows based on garter stitch (this will be the beginning of the ribbon). After all on the edge of the long side of the tape, you need to dial ten loops, after which you have to raise three or four dials on the right of the knitting needle. In total, sixteen or eighteen loops should form on the spoke (here the total dependence on the width of the tape is three or four loops).
That's how they begin to knit a shawl "Clematis". Scheme and description (knitting it with knitting needles more often than with a crochet) make it clear that this is really a labor-intensive work.
Knitting shawls further occurs on the basis of the first scheme from the very beginning, that is, from the first row. On the seventeenth row, the foreman should rotate the rapport several times-five (among the ribbons).
In the nineteenth row, among the ribbons, one must make a cape, five rapports, a cape.
In the twenty-first row - ribbon, one obverseloop, nakid, then all rapport left to the end, four whole rapports, a cape, one obverse loop, a ribbon. In the twenty-third row there is a ribbon, two facial loops, a cape, the whole report to the very end, four whole rapports, two facial, a ribbon.
Similarly, knit further based on the scheme.
The second and third schemes
Very carefully, even an experienced craftsman, you should knit a shawl "Clematis". A diagram or diagrams are attached to it, but one must be very careful.
Work with the second scheme does not represent a speciallabor. Here it will be necessary to knit until the end of a series of schemes and do so five times. The series ends, without which it is impossible to tie the shawl "Clematis" (descriptionis given very detailed) with a loop in the yellow column.
Now the next, the third stage. Knitting here goes strictly according to scheme 3. From 150 to 108 rows - all facial smoothness. Such a strip can go along the front side of the shawl "Clematis" with hinges either in the front or in the back (everything depends on what the masters preferences are).
The edge begins with the 109th row. In this case rapport must be knit ten times in all rows.
Attention: one of the ten rapports should be divided in half. The left part will be tied at the very beginning of the row, after the tape (starts with a loop that is marked with yellow lines). The right will be at the end of the row, in front of the ribbon. It will end with loops, which are marked with yellow lines.
Attention in work will not hurt
It should be noted that in the 109th row, among the ribbons, there should be 321 loops (this is five rapports).
When knitting the 124th row, the masters shouldmark the cues with markers (check the marks in front of them). These nakidy in the purl series are tied with two eyelets (this is done in order to distinguish them from ordinary capers, which are knitted with simple backing loops).
Next, the master must be extremely attentive: The 130th row - the purl loops do not match, and the previous one - the 129th, will be the final one. It must be tied according to the scheme, completely without crochet. In this case, the skilled worker binds this 129th row freely.
The loop of the final row should be closed.
That's how the shawl "Clematis" matches. Scheme and description (crochet here you should close the loop of the final row) give you a clear understanding of what and how to do. According to the scheme, it is necessary to fasten as many loops as possible without the crochet, how many of them are indicated (this is in the place where braces are combined); Among the columns it is necessary to connect eight air loops of arches.
Now it is not difficult to understand howknitted shawl "Clematis". The scheme and description of all the work from the beginning to the end will enable the master to do everything as accurately as possible and later to enjoy the result of her labors.